How To Give A B12 Intramuscular Injection References. (3) push the plunger into the syringe barrel with a slow, continuous downward movement as far as the plunger will go. Ventrogluteal intramuscular injection site’ (see diagram above).
Remove the cap from the needle. Put on gloves if necessary. Dispose of the needle and syringe as instructed.
Place An Alcohol Swab Or Gauze At The Injection Site And Put Pressure On The Site For 30 Seconds To 1 Minute.
(3) push the plunger into the syringe barrel with a slow, continuous downward movement as far as the plunger will go. Remove the cap from the needle. Do not give yourself an injection in the same place every time.
The Vitamin May, However, Be.
Clean the skin at that spot with an alcohol wipe. Wash your hands well with soap and water. Inject medication slowly but smoothly;
Throughout These Stages I Was Given The Opportunity To Discuss Any Questions, Feelings Or Concerns That Arose.
Explain the benefits of the injection to the patient; Remove the needle from the injection site. Setting up for the injection.
Draw Back The Plunger To Fill The Syringe.
Monitor b12 level every 6 months for 3 years. The ontario drug benefit (odb) database was used to identify patients who were prescribed vitamin b12 injections, and the ontario health insurance plan database was used to identify all. Push the needle through the rubber seal on top of the vial.
Dispose Of The Needle And Syringe As Instructed.
An intramuscular injection, as illustrated in the figure below, delivers medication deep into the muscle tissue. Pull back the plunger to the line on your syringe for your dose. The correct area to give the injection is two finger widths below the acromion process.