close
close

How To Change Code On Schlage Lock Keypad Ideas

How To Change Code On Schlage Lock Keypad Ideas. Reconnect the battery and wait until the schlage button is no longer lit. Remove the battery connector and then press and hold the schlage button on the keypad.

Schlage Camelot Aged Bronze Keypad Electronic Deadbolt
Schlage Camelot Aged Bronze Keypad Electronic Deadbolt from www.homedepot.com

6dmc + schlage button + #1 + new 4duc + reenter 4duc. You should see the “schlage” button flash and usually beep as well three times in a row. Without the booklet there is only one other place to find this code.

Try Again After 30 Seconds.

First, open the door and lift off the lock’s interior cover.follow these steps to change the programming code on a schlage keypad lock:go to keypad.schlage.com for videos and more. To add a new entry code: On the lock keypad, press and release the schlage.

Wait For The Schlage Button To Beep And Flash Three Times.

On the lock keypad, press and release the schlage button. Via the keypad, enter the existing programming code (the one you want to change) and wait for three orange lights from the schlage button, followed by three beeps. Press the schlage button and then enter the 6 digits default programming code.press the schlage button and then press 2.pushing the shlage button and the 1 key primes the lock to accept a new entry code.

Without The Booklet There Is Only One Other Place To Find This Code.

How to change code on schlage lock keypad. Preparing the system of the lock to accept the new key code. Vacation mode is used to disable all user codes at the keypad.

Before You Change The Code Of Your Schlage Lock, Make Sure That The Door Is Open Since You Will Need To Have Access To The Interior And Exterior Assembly Of The Lock.

With that in mind here are the instructions to change the code on your be and fe series schlage keyless deadbolt locks and lever handle locks: Next, press the schlage button. Press the schlage button and the number 1 button at the same time.

Press The Schlage Button On The Keypad And Then Press Key 3.

Follow the steps below to program new user codes on your schlage keypad lock: Pushing the shlage button and the 1 key primes the lock to accept a new entry code. See restore factory settings on page 15.

Leave a Reply

Your email address will not be published.